The DVR, NVR, or camera sends out an alert to the phone which then shows up as a push notification. The phone monitoring apps the communication mode between your phone and your remote security system. Moreover, for security reasons, it’s always recommended to keep your security devices up-to-date. If this algorithm is buggy or not properly implemented you may get scenarios where the motion is not detected at all or getting alerts a few seconds after the motion has started.įor this reason, updating your security camera firmware or the firmware of NVR/DVR to the latest version could eliminate any bugs that have been affecting the motion detection or push notification. This software is quite complicated and tracks the motion based on the pixel difference between each consecutive frame. Update the firmwareĪs we said at the beginning of this article, the most popular motion detection is the algorithmic-based one. These features vary between manufacturers, but the logic is the same across all platforms. If you click you can see the activity that was recorded and simply go to the live view mode. Once a motion event happens in your security camera system, you’ll get an alert (push notification) at the top of your phone screen. Additionally, you need to authorize the phone to let these alerts show on your phone screen. Most of the CCTV apps have a single toggle on the phone where you can enable the alerts. After that, you can enable the push notifications on the app’s settings. ![]() Make sure you can see the cameras on the phone (live view playback). These settings vary between manufacturers, however, the idea is to link the CCTV phone app to your camera or DVR/NVR and get alerts once the motion is triggered. ![]() You may have activated the motion detection correctly but you’re still not getting any notifications on the phone and that’s because you need to set up the push notifications separately. Set up the push notifications on the phone app Another suggestion is to reset the motion detection schedule and re-do the settings from the beginning.Ģ. These include settings such as increasing the sensitivity level depending on the object size or longevity of the motion, adjusting the contrast. If you did these settings and the motion still doesn’t work, then adjust the sensitivity and threshold level. Keep in mind, some security cameras will initiate motion detection by default while some have it disabled. These tweaks are done on the settings section of your camera or NVR DVR. ![]() There are two things you need to do: first, you have to enable the motion detection for each camera, second, you need to set up your system to record on motion (and not continuous mode). The motion detection settings need to be configured and activated in order for the system to detect motion alerts. If your security camera system never detected any motion, most likely the motion feature was never enabled in the first place. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |